| snippet:
|
Exceedance areas of Normalized Burn Ratio Difference (dNBR) and ground slope for the California Fires May 2026. |
| summary:
|
Exceedance areas of Normalized Burn Ratio Difference (dNBR) and ground slope for the California Fires May 2026. |
| extent:
|
[[-118.86940216392,34.1366342422334],[-118.619839658845,34.2531014986656]] |
| accessInformation:
|
NASA Disasters Program, USGS, ESA Copernicus |
| thumbnail:
|
thumbnail/thumbnail.png |
| maxScale:
|
1.7976931348623157E308 |
| typeKeywords:
|
["ArcGIS","ArcGIS Server","Data","Map Service","Service"] |
| description:
|
<div style='text-align:Left;'><div><div><p><span style='font-weight:bold;'>Dates of Images:</span></p><p><span>Post-Event: May 24, 2026</span></p><p><span>Pre-Event: May 7, 2026</span></p><p><span style='font-weight:bold;'>Date of Next Image:</span></p><p><span>Unknown</span></p><p><span style='font-weight:bold;'>Summary:</span></p><p><span>These pre-fire and post-fire images pair were analyzed for normalized burn ratio (NBR). The input images were generated from the Harmonized Landsat Sentinel-2 (HLS) dataset at 30m resolution.</span></p><p><span>NBR is defined mathematically as (NIR – SWIR)/(NIR + SWIR) where NIR is near-infrared and SWIR is short-wave infrared. dNBR is computed by the difference between the pre-fire NBR and the post-fire NBR. More information on dNBR can be found here: https://un-spider.org/advisory-support/recommended-practices/recommended-practice-burn-severity/in-detail/normalized-burn-ratio.</span></p><p><span>dNBR data may be computed while the fire is in progress. This is intentionally done to prioritize rapid data availability for proactive disaster response but means data can change over the course of the fire.</span></p><p><span>Ground slopes were calculated using the slope algorithm in QGIS. This algorithm determined ground slopes in degrees by analyzing USGS 1/3 arcsecond (i.e. roughly 10m) digital elevation rasters in the NAD27 / UTM zone 13N projection.</span></p><p><span>To produce the dNBR and ground slope exceedance map, dNBR data was filtered for values greater than 0.4 and ground slope data was filtered for areas greater than or equal to 23 degrees. These thresholds were defined by NASA subject matter expertise to indicate critical levels for enhanced debris flow risk where both are in exceedance. The locations where both dNBR and slope thresholds were exceeded were initially identified in a binary raster and then vectorized to polygons using 8-neighbor feature selection (data represented here).</span></p><p><span style='font-weight:bold;'>Suggested Use:</span></p><p><span>dNBR is commonly used as a proxy to identify fire-affected areas. Higher dNBR value are statistically correlated with greater burn severity, where negative dNBR values may represent a re-greening of or growth of vegetation in between pre and post-vegetation.</span></p><p><span>The use of this dNBR product as a quantitative metric of burn severity at the time of posting this dataset should be strongly caveated. This is due to several dNBR limitations:</span></p><p><span>The spectral band selections used for dNBR calculations, and the implication of changes observed following fire in those wavelengths, primarily pertain to how vegetation spectral signatures change in NIR and SWIR wavelengths following charring. Because of this, dNBR will not accurately describe burned surfaces that are not vegetation (e.g. human built infrastructure), and the interpretation of dNBR values may vary widely based on the type of vegetation burned.</span></p><p><span>This dataset has not been validated by independent burn severity assessments.</span></p><p><span>The degree to which dNBR is accurately determined depends on careful selection of pre and post event imagery. An effort was made to use the highest quality imagery (i.e. cloud free) with representative conditions for each scene; however, it is unknown at the time of this posting how selection of different pre/post image pairs could affect the derived dNBR values.</span></p><p><span style='font-weight:bold;'>Satellite/Sensor:</span></p><p><span>NASA Disasters/MSFC, USGS, ESA Copernicus</span></p><p><span style='font-weight:bold;'>Resolution:</span></p><p><span>10 meters</span></p><p><span style='font-weight:bold;'>Credits:</span></p><p><span>NASA Disasters Program, USGS, ESA Copernicus</span></p><p><span style='font-weight:bold;'>Esri REST Endpoint:</span></p><p><span>See URL section on right side of page</span></p><p><span>WMS Endpoint:</span></p><p><span>https://maps.disasters.nasa.gov/ags03/services/NM_FIre_202506/dnbr_hls/MapServer/WMSServer</span></p></div></div></div> |
| licenseInfo:
|
<div style='text-align:Left;'><div><p><span>NASA data and products are freely available to federal, state, public, non-profit and commercial users. This information can be experimental- or research-grade data products and may not be appropriate for operational use. These NASA data products, services, and the Disasters Mapping Portal are intended to aid decision makers and enhance situational awareness, but these data are not guaranteed to be consistently available or routinely updated. Use of this product should include: "Contains modified Copernicus Sentinel data (2026) processed by ESA</span></p></div></div> |
| catalogPath:
|
|
| title:
|
sentinel2_dnbr_slopeExceedance |
| type:
|
Map Service |
| url:
|
|
| tags:
|
[] |
| culture:
|
en-US |
| portalUrl:
|
|
| name:
|
sentinel2_dnbr_slopeExceedance |
| guid:
|
586B67F5-7A59-4CED-887E-93B0D0D621EF |
| minScale:
|
0 |
| spatialReference:
|
WGS_1984_UTM_Zone_11N |